• 3X(1 set For Prusa i3 MK2 / MK3 3D clone printer Btech double gears DIY Prusa RK

3X(1 set For Prusa i3 MK2 / MK3 3D clone printer Btech double gears DIY Prusa RK
3X(Press the nuts to the slots on both sides of the idlerInsert both bearings in the pulley,Be aware that bearings can slip out during assembly.(Layers might be visible in this printed part due to the geometry .The functionality and strength remain unaffected)Ensure both bearings are inside the pulley!Slide the shaft through the idler and pulley.Use reasonable force or you will BREAK the printed part.Place your finger on the bearing and ensure it can rotate freely.Color: picture colormaterial: metalPackage Contents: 1 x pulley (with locking screw)1 x pulley (without the locking screw)2 x pulley2 x M3nS nut1 x pulley shaft)

Write a review

Note: HTML is not translated!
    Bad           Good

3X(1 set For Prusa i3 MK2 / MK3 3D clone printer Btech double gears DIY Prusa RK

  • Product Code:
  • Availability: In Stock
  • $25.18

  • Ex Tax: $25.18